Pool Service Software for a Seasonal Route: What You Pay When the Pools Are Closed

Pool Runs Team
··8 min read
Two pool technicians tensioning a green mesh safety cover across a backyard pool on an overcast late-autumn day, anchor springs and straps laid out on the leaf-strewn concrete deck

Share

Every comparison of pool service software you will find online prices a single month, and it is always a busy one. If you work in Phoenix or Orlando that is reasonable, because your busy month is most of your months. If you work anywhere that puts covers on pools in October, it describes less than half your year and the better half at that.

This piece does the other half. Five platforms, every figure read from the vendor's own pricing page and re-read on 11 November 2026, priced across a route that closes most of its book for the winter. The question is not which one is cheapest in July. It is where each one stops falling, what a single pool ends up costing you in February, and which lines on your bill move with the calendar at all. Pool Runs publishes this and sells pool service software; where a competitor is cheaper on this measure, it says so.

Why the floor matters more than the rate

Most pool platforms bill on serviced locations, which sounds perfectly suited to a seasonal route: you stop visiting a pool, it stops counting, the bill falls. That is true, but only down to a point. Almost every one of them wraps a block of pools into the base price, and once your route drops below that block the bill stops moving. You are then paying for capacity you are not using, and the per-pool rate that looked so important in July has no effect on your February invoice at all.

Included bucket
The number of serviced locations covered by a platform's base price. Above it you pay a stated rate per extra location; below it the bill is flat, because the base price is a minimum rather than a starting point. On a seasonal route the included bucket is usually the single most important number on a pricing page, and it is almost never the number in the headline.

Here is where each platform stops falling. Everything below was read from the vendor's own pricing page and re-read on 11 November 2026.

Where each platform's bill stops falling

EZ Pool Biller

The floor
$35/mo
Pools that buys you
60 locations
What happens below it
Nothing changes. Sixty pools or six, the bill is $35

Skimmer Getting Started

The floor
$49/mo
Pools that buys you
49 locations
What happens below it
Flat at $49, at 49 pools or at nine

Skimmer Scaling Up

The floor
$98/mo
Pools that buys you
49 locations
What happens below it
Flat at $98, and this is the tier its page states for 50-1,000 pools a month

PoolDial

The floor
$40/mo minimum
Pools that buys you
20 pools at $2 each
What happens below it
Flat at $40 below twenty pools. No included bucket above it

Pool Runs

The floor
$45/mo
Pools that buys you
50 properties
What happens below it
Flat at $45, at 50 properties or at five

Pool Office Manager

The floor
$125/mo
Pools that buys you
One active user
What happens below it
Not pool-based at all. The bill moves with users, never with pools

Read on 2026-11-11 at ezpoolbiller.com/pricing, getskimmer.com/pricing, pooldial.com/pricing, poolofficemanager.com/pricing and poolruns.com/pricing. Skimmer states Getting Started for routes of 0-49 pools a month and Scaling Up for 50-1,000, so which floor applies to you depends on your peak rather than your trough. Pool Office Manager states its prices are current as of October 2026. Pool Brain is left out of this table because its published pricing page renders its plan amounts as a blank '$ /Month'; only a $65 per-technician rate is legible, which is not enough to price a season from.

Two things in that table are worth sitting with. The first is that PoolDial is the only platform of the five with no included bucket at all — its $40 is a true minimum rather than a block of pools, so every pool above twenty costs the same two dollars whatever the month. The second is that Skimmer's floor depends on a judgement rather than a count: its page states Getting Started for routes of nought to 49 pools a month and Scaling Up for 50 to 1,000, and a northern route crosses that boundary twice a year. Which tier a seasonal operator is supposed to sit on is not something either the page or any comparison table answers.

What one pool costs you in February

Divide the monthly bill by the pools you actually serviced and you get the only number that compares a July to a February honestly. Below, the same five platforms at four route sizes, with the busy month included at the bottom so the swing is visible. Every figure is arithmetic on the published rates and nothing else.

Cost per serviced pool, from published rates, at four route sizes

15 (deep winter)

EZ Pool Biller
$2.33
Skimmer
$3.27
PoolDial
$2.67
Pool Runs
$3.00

30 (early spring)

EZ Pool Biller
$1.17
Skimmer
$1.63
PoolDial
$2.00
Pool Runs
$1.50

60 (opening season)

EZ Pool Biller
$0.58
Skimmer
$2.00
PoolDial
$2.00
Pool Runs
$1.04

250 (July)

EZ Pool Biller
$0.52
Skimmer
$2.00
PoolDial
$2.00
Pool Runs
$1.58

Monthly bill divided by pools serviced, rounded to the cent, from rates read 2026-11-11. Skimmer is shown on the tier its own page states for that route size: Getting Started at 15 and 30 pools, Scaling Up at 60 and 250. PoolDial is $2 a pool with a $40 monthly minimum, which binds at 15 pools; its page states a 14-day free trial. Pool Runs publishes volume pricing above 200 properties without stating a figure, so the 250-pool row uses the published $1.75 and the real cost would be lower. Excludes payment processing, texting, add-ons and tax.

The headline is the top row. In a fifteen-pool February every one of these platforms costs more per pool than it does in a two-hundred-and-fifty-pool July, and on three of the four it costs four or five times as much. That is not a vendor being greedy; it is simply what a floor does. But it means the sentence "we charge a dollar seventy-five a pool" — ours included — is only true in the months when you are above the included bucket, and a seasonal operator spends a good part of the year below it.

Notice also how differently the two shapes behave. EZ Pool Biller and Pool Runs both get dramatically cheaper per pool as the route fills, because the included bucket spreads over more pools and the marginal rate is low. PoolDial does not move at all: two dollars is two dollars at 30 pools and at 250. Whether that is good or bad depends entirely on where you spend your year. A route that is small all year round is better off on a platform with a generous bucket. A route that swings hard between 15 and 250 pays PoolDial the same rate at the top of the swing as at the bottom, which is worse in winter and better in summer than the bucket platforms.

The subscription is usually the only line that falls

Card and ACH processing fees, your business phone number, website hosting, your accounting subscription and any texting plan all bill the same in February as they do in July. On most seasonal routes the software subscription is the one line on the stack that tracks the calendar, which means the real off-season saving is smaller than the per-pool arithmetic on its own suggests. Price the whole stack across twelve months, not just the platform.

Per-user platforms run the other way round

Everything above assumes the bill is attached to pools. On a platform priced per user it is attached to people, and closing 180 pools changes nothing at all — the same crew is still on the payroll in February, so the same seats are still billed. Pool Office Manager is the clearest example on the board, and to its credit it says so and offers an answer: $125 a month for the first user and $25 for each additional active user, with its pricing page stating plainly that seasonal companies can deactivate users during the off-season. We compared that model against a per-pool one in more detail in Pool Office Manager vs Skimmer.

That turns the off-season question into a staffing question, and the arithmetic is worth doing honestly rather than assuming the per-pool model always wins. A ten-technician company on Pool Office Manager pays $350 a month in season. If eight of those technicians come off the books from November through March and you deactivate their logins, the winter bill is $150. That is a real and substantial fall — but it is only available if you genuinely lay people off, and plenty of owners keep their best technicians on through the winter doing closings, repairs and equipment work precisely so they still have them in April. If that is you, a per-user platform bills you at full summer rate for the whole off-season while a per-pool one does not.

Two pool technicians in company polo shirts loading sealed chlorine jugs and a bucket of tablets into the bed of a second service truck at dawn, a backyard pool and block service building behind them
On a per-user platform the off-season lever is headcount. On a per-pool one it is the number of covers you take off.

Pool Brain sits in a third category, priced per technician, and it cannot be included in any of the arithmetic above for a practical reason rather than a strategic one: its published pricing page currently renders its plan amounts as a blank dollar sign followed by "/Month", with only a $65 per-technician rate legible anywhere on it. That has been the case on every reading we have taken since early October. We are not going to guess at a number in order to fill a cell.

Price is only half of it: what a closing season asks of the software

Everything so far is about the invoice, which is the half that is easy to compare because the numbers are published. The half nobody publishes is whether the system can actually handle a route that empties and refills every year. A platform built for Florida assumes a customer is either active or gone. A northern route needs a third state — on the books, not being visited, not being billed, and coming back in April with every equipment note intact.

The sequence below is the one a seasonal account goes through every year, and it is worth walking a trial account through all five steps before you commit rather than discovering in March that step four means re-entering ninety customers by hand.

What a seasonal account does between October and April
Closing work orderAccount marked inactiveWinter checks loggedReopening scheduledBilling resumes

Step two is the one that connects the two halves of this piece. On a platform that counts a property only in a month it had a completed visit — which is how Pool Runs bills, and how Skimmer, EZ Pool Biller and PoolDial describe their own billing — marking an account inactive for the winter is simultaneously an operational act and a billing one, and you do not have to choose between keeping the record and keeping the cost down. On a per-user platform it is purely operational, because the bill was never attached to the pool in the first place. Either way, the thing you must not do is delete closed accounts to shrink a bill: the service history, the equipment notes and last year's opening instructions are precisely what makes April cheap, and they are expensive to rebuild.

Six things to settle before you buy for a seasonal route

The off-season buying checklist

0 / 6

Pool Runs on a seasonal route, honestly

Where we fit and where we do not

Where it fits

  • A property only counts in a month it has a completed visit, so a pool under a cover from November to April costs nothing in those months
  • Users and technicians are unlimited at every route size, so keeping your best people on through a quiet winter never moves the software bill
  • Every feature is in the one $45 core plan rather than split across tiers, so there is no band to cross twice a year as the route opens and closes
  • The $45 floor is the second lowest of the five platforms here and it covers 50 properties

Where it does not

  • There is still a floor. At 15 serviced pools you pay the same $45, which works out at $3.00 a pool — the second highest figure in the February row
  • EZ Pool Biller's $35 floor is lower than ours and covers more pools, so it is cheaper than Pool Runs in every winter month modelled here
  • We publish volume pricing above 200 properties without stating the figure, which makes a full-year total harder to work out than it should be
  • We publish no card or ACH processing rate, and that line does not shrink in the winter the way the subscription does

If you want the two-platform version of this with a full twelve-month total worked out, we did that in EZ Pool Biller vs Skimmer. And if the reason you are reading this is that the winter bill is making you wonder whether your service rate is high enough in the first place, that is a different question with a better answer: our pool service pricing guide covers how to read a rate benchmark against your own cost floor before you change anything.

One last thing worth saying for northern routes specifically. Spas very often stay open through the winter on properties whose pool is closed, and a spa-only visit is still a serviced visit — which is both a revenue line and a billing line, and is handled differently by different platforms. We cover that in pool and spa service software. And whatever you decide, keep the closed accounts' records intact rather than deleting them to get under a floor: the history, the equipment notes and the opening instructions are what make April cheap, and keeping customer records costs nothing on a platform that bills on visits. If you want to run your own numbers against ours, you can start a 30-day trial and put a real month of billing through it before the season turns.

Ready to try Pool Runs?

See how Pool Runs can streamline your pool service business.

Don't miss these